ASA S1.20-2012 (R2020)

September 11, 2020 by No Comments

Click here to purchase
This standard establishes measurement procedures for calibrating underwater electroacoustic transducers. It is a revision of American National Standard S1.20-1988 (R2003). Both primary and secondary calibration procedures are specified for frequencies from a few hertz to a few megahertz. Procedures are specified for determining the measurable characteristics of free-field receive voltage sensitivity, transmitting response, directional response, voltage coupling loss, impedance, and equivalent noise pressure. Measurement uncertainty analysis is introduced for these measurement types, with identification of common error sources. Equations are given for the following derived characteristics: beam pattern, directivity factor and index, equivalent two-way beam width, acoustic power output and level, electrical power input, transmitting efficiency, open-circuit effective bandwidth, and quality factor. Annexes have been included to address: A) free-field calibration in a laboratory tank, B) medium correction factors, C) measurement of sensitivity and response?infrasonic and low audio-frequency range, D) phase of free-field voltage sensitivity via reciprocity method, E) nonlinear effects including cavitation, and F) standard-target method for calibrating active sonars.

Product Details

Published:
02/17/2012
ANSI:
ANSI Approved
Number of Pages:
64
File Size:
1 file , 780 KB