PIP VESLP001

December 5, 2022 by No Comments

Click here to purchase

This Practice provides requirements for the construction of low-pressure, welded vessels that in general meet the philosophy and requirements of Section VIII, Division 1 of the ASME Boiler and Pressure Vessel Code (Code), but do not require Code inspection or stamping. Vessels may be shop or field fabricated. This Practice describes the basic requirements for the design, materials, fabrication, examination, inspection, and testing of aboveground, welded, cylindrical shell, single-wall vessels having a nameplate with an internal and external Design Pressure not greater than 103 kPa (15 psig) at the top of the vessel in the normal operating position. An additional specification may be required to define options covered herein and other specific requirements considering service (startup, normal operation, upset, shutdown), location, maintenance, etc. The documents listed in Section 2.1 shall be used for a complete purchase specification. This Practice is not intended for flat-bottom tanks or API-type field-erected storage tanks. Unless approved by Purchaser, this Practice is not to be used for low-pressure vessels that will contain “Lethal Substances” as defined in Code Endnote 64.   

Product Details

Published:
05/01/2022
Number of Pages:
22
File Size:
1 file , 310 KB
Note:
This product is unavailable in Ukraine, Russia, Belarus

PIP VESLP001

September 11, 2020 by No Comments

Click here to purchase
This Practice describes the general materials, design, fabrication, examination, inspection, testing, and documentation requirements for the construction of low-pressure, welded, shop-fabricated vessels that generally meet the philosophy and requirements of Section VIII, Division 1 of the ASME Boiler and Pressure Vessel Code, henceforth referred to as the Code. However, Code inspection and stamping are not required.

Product Details

Published:
09/01/2007
File Size:
1 file , 98 KB

PIP VESLP001

September 11, 2020 by No Comments

Click here to purchase
This Practice provides requirements for the construction of low-pressure, welded vessels that generally must meet the philosophy and requirements of Section VIII, Division 1 of the ASME Boiler and Pressure Vessel Code (Code), but do not require Code inspection or stamping. Vessels may be shop or field fabricated.

This Practice describes the basic requirements for the design, materials, fabrication, examination, inspection, and testing of aboveground, welded, cylindrical shell, single-wall vessels having an internal and external Maximum Allowable Working Pressure (MAWP) not exceeding 15 psig at the top of the vessel in the normal operating position. An additional specification may be required to define options covered herein and other specific requirements considering service (startup, normal operation, upset, shutdown), location, maintenance, etc. The documents listed in Section 2.1 should be used for a complete purchase specification.

Product Details

Published:
06/01/2012
Number of Pages:
21
File Size:
1 file , 270 KB